ElmoMC ExtrIQ Gold Line Servo Drives-Gold Panther - Manual (Page 55)

Gold Panther Installation Guide
MAN-G-PANIG-EC (Ver. 1.000)
|Communications| www.elmomc.com
55
Table of Contents
5.5.3. EtherCAT Communication (J2)
To use EtherCAT and Ethernet communication with the Gold Panther, it is required to use an
isolation transformer. The most common solution is to use RJ-45 connectors that include
transformer isolation.
This section describes how to connect the Gold Panther’s EtherCAT interface using the above
mentioned connectors.
Notes for EtherCAT communication:
1. The EtherCAT IN port can be configured as an Ethernet port for TCP/IP – see the EtherCAT
Manual.
2. It is recommended to use CAT5e (or higher) cable. Category 5e cable is a high signal integrity
cable with four twisted pairs.
Pin (J2) Signal Function
26 3.3 V 3.3 V for EtherCAT LEDs
31, 32 PHY_IN_COMRET EtherCAT Communication Return
27 PHY_IN_RX+ EtherCAT IN RX+ Line
29 PHY_IN_RX- EtherCAT IN RX- Line
33 PHY_IN_TX+ EtherCAT IN TX+ Line
35 PHY_IN_TX- EtherCAT IN TX- Line
39 PHY_IN_SPEED Indicates EtherCAT Speed
37 PHY_IN_LINK_ACT Indicates EtherCAT LINK
31, 32 PHY_OUT COMRET EtherCAT Communication return
28 PHY_ OUT _RX+ EtherCAT OUT RX+ Line
30 PHY_ OUT _RX- EtherCAT OUT RX- Line
34 PHY_ OUT _TX+ EtherCAT OUT TX+ Line
36 PHY_ OUT _TX- EtherCAT OUT TX- Line
40 PHY_ OUT _SPEED Indicates EtherCAT Speed
38 PHY_ OUT_LINK_ACT Indicates EtherCAT LINK
Table 21: EtherCAT - Pin Assignments