ElmoMC ExtrIQ Gold Line Servo Drives-Gold Hawk - Manual (Page 61)

Gold Hawk Installation Guide Installation
MAN-G-HAKIG (Ver. 1.001)
www.elmomc.com
61
4.11.2. CAN Communication (J2)
Note that CAN functionality is not available if you have the EtherCAT version.
In order to benefit from CAN communication, the user must have an understanding of the basic
programming and timing issues of a CAN network.
Notes for connecting the CAN communication cable:
• Connect the shield to the ground of the host (PC). Usually, this connection is soldered
internally inside the connector at the PC end. You can use the drain wire to facilitate
connection.
• Ensure that the shield of the cable is connected to the shield of the connector used for
communications. The drain wire can be used to facilitate the connection.
• Make sure to have a 120 Ohms resistor termination at each of the two ends of the network
cable.
• The Gold Hawk’s CAN port is non-isolated.
Pin (J2) Signal Function
32 CAN_COMRET CAN Communication Return
38 CAN_L CAN_L bus line (dominant low)
40 CAN_H CAN_H bus line (dominant high)
Table 20: CAN Pin Assignments