DIGIWEIGH DWP-C2X - Manual (Page 8)

5
3
Press (*)
[ ＊ ＊ ＊ ＊
＊]
[CAL 1 ]
If input incorrect password, it will
return back to weighing state.
If input correct password, it will
enter into Calibration.
Remarks:
1.Press(H)button to quit the password inputting at any time and return to weighing status.
2. Can enter into parameter setting and calibration only after input the password correctly.
3. After complete the password input it will automatically quit accumulation status.
4. Can not enter into
“password input" under “Tare" status.
Chapter 7 Parameter setting (Setup)
1. Can not have parameter set under the "Tare" situation, should quit first.
2. In the state of “Parameter Setting “, press (▲) will plus, every press on (—›0<—) will minus,
press (*) as confirmation and enter into next operation, press (H) to quit setup status
Step Operation Display Remarks
1
Press(*)
after
password
confirmed [ CAL 1 ] Option: CAL 1 to setup the
parameter
CAL
2 to enter into
calibration
2
Press(▲)
Press(*)
[ dc ＊]
[ dc 0]
Set decimal digits
Press (▲) to choose the decimal
digits, option: 0/1/2/3
Enter into next parameter
setting( Division Value)
3
Press (▲)
Press
[ d ＊＊]
[ d 1 0 ]
Set Division Value
Press(▲) to select the required
Division value
Enter into next setting
4
Press(*)
Press(*)
Press(*)
[ ＊＊＊＊
＊]
[ 0 0 0 0 0 ]
[ 0 3 0 0 0 ]
[ 0 3 0 0 0 ]
[ 0 3 0 0 0 ]
Set the max. Weighing range
With the highest digit flashing, press
(
▲) to choose the figures.
The fourth digit flashes, press (▲) to
choose the figures, for example press 3
times of (▲) it will show 3.
Press (*) the figures stop flashing
P
ress (▲), when the highest digit
flashes, enter into resetting the max.