DIGIWEIGH DWP-98D User Manual
Page 16
6.4 TARE OFF THE WEIGHT OF A CONTAINER
1
Tare function is used to temporarily set the instrument to zero (such as
cancelling the weight of a box or a container) in order to get the net weight
result
6.4.1 Enable / Disable Repeat (Multiple) Tare
Depends on internal function setting, repeated (multiple) tare operation may
be enable (Mode 2) or disabled (Mode 1). Contact your dealer for more
information.
When repeat (multiple) tare is enabled: -
1.
the instrument will permit multiple tare operations provided that
both of the below requirements are fulfilled: -
The tare operation does not permit a reduction of the value of
the tare;
The tare effect can only be cancelled when there is no load on
the platter.
2.
tare effect can only be cancelled when container is removed and
gross weight is zero.
6.4.2 Manual Tare
When a container is used, follow the below steps to tare the weight of the
container off to get a net weight result.
a. Remove all loads from platter,
b. Make sure that the Zero Indicator is on. If not, press [ZERO] to set
weight reading to zero,
c. Place container on platter,
d. Press [TARE],
e. Net Indicator appears to indicate tare is in effect and weight reading
is net weight.
f.
To cancel tare effect, remove all loads and container from platter and
press [TARE] ,
1
The tare weight is deducted from the weighing capacity (Max), reducing the
maximum weight that can be displayed.