DIGIWEIGH DWP-98D - Manual (Page 15)

6. INSTRUCTION FOR USE
6.1 POWER ON /OFF
Press on/off key for 2 seconds on panel, instrument is on and displays: -
a. software and revision number and capacity of instrument,
b. countdown process starts
c. all LCD segments,
After that, the instrument is ready for operation.
d. the Arrow P1 or P2 will show which is the current platform
Press on/off key for 2 seconds when the scale is on and in weighing status
to switch off the scale
6.2 START WEIGHING
a. If zero weight cannot be obtained when unloaded, press [ZERO].
After [ZERO] is pressed, Zero Indicator appears.
Refer to SPECIFICATIONS for maximum zero range,
b. Always place an object onto platter gently. Excessive force applied to
platter may cause damages to the weight sensor inside instrument,
c. Weight of the object is displayed on thus unit automatically,
d. It is a good practice to remove all loads from platter after weighing. It
will prolong the life of the weight sensor inside instrument.
6.3 ABOUT WEIGHT UNIT CONVERSION
The instrument supports conversion among weight units. Press [UNIT] to
shift between kg, g and lb.
To enable or disable a particular weight unit, set it ON or OFF respectively
in internal Unit.
The weight unit being employed before power off will be employed when
turned on again.
Note: Select the suitable unit before counting function. Can not change unit
during counting function.