DIGIWEIGH DWP-800 DWP-102E Indicator User Manual
Page 6
- 5 -
cancel hold function.
3.8 Presetting tare value (KEY=4)
Press MOD Key to preset tare value. While every weighing, the value displayed is the one actual weight substrate the preset tare value.
3.9 Animal weighing (Key=5)
Press MOD Key to set parameters of animal weighing.
1) Stable time
“Fil n”. Options: 1/2/3/4/5. 1 is the fastest and 5 is lowest. The longer of stable time, the harder to lock.
2) D
isplay range “Rang n”. Options: 1/2/3. Option 2 is recommended.
3) Leaving lock range. If the change of weight exceeds the value, the indicator will get a new display.
Press FUN Key to enter or cancel the animal weighing function.
3.10 Check-Weighing
Check-weighing is a procedure to cause alarm to sound when the weight on the scale meets or exceeds values stored in memory. The
memory holds values for a high limit and a low limit.
Check range:
Set hi-limit and low-limit as different values, and hi-limit value is larger than low-limit value.
Check key point:
Set hi-limit and low-limit as same value.
Check mode:
Setting the parameter: Select
”F4 CHK” to enter check mode. Press FUN Key to enter and sub select “BEEP 1, BEEP 2 or BEEP 3”;
Press FUN Key, it will show
“XXXXXX”. Then begin to set high-limit value; Press Enter to set low-limit value;
Mode 1: BEEP=1, never beep whether it is eligible or not, but the indicator HI or LO will be on or off to show the result. When the weight is
higher than the high-limit, indicator HI will be on, while lower than the low-limit indicator LO will be on. Otherwise indicator HI & LO will
be both on.
Mode 2: BEEP=2, beep when it is eligible;
Mode 3: BEEP=3, beep when it is not eligible.
Note: The weight must be greater than 9 scale divisions for the check weighing to operate. To disable the check-weighing function
press UNIT Key to set both high and low limit to zero.
3.11 Print (KEY=2)
Set
“P10 PS”: “RS Prt” is selected for the Serial Printer.
When weighing, press MOD Key to print.
SECTION 4 FUNCTIONS AND PARAMETERS
“F1 CLK”: Date and time setting
When
“F1 CLK” is showed, press FUN Key. It will display the time.
Time setting: ZERO Key: shift digit; MOD Key: cancel and esc;
TARE Key: value up; FUN Key: enter and esc;
Select date setting mode by pressing TARE Key.
“YY-MM-DD”, “MM-DD-YY” or “DD-MM-YY”
Date setting: Same as time setting.
“F2 SLP”: Sleep function For LED Version