DIGIWEIGH DWP-800 DWP-102E Indicator - Manual (Page 4)

- 3 -
3) Move the cursor to change the digit when setting parameters or other functions.
TARE Key
1) When self-checking, Press TARE Key to enter fast calibration;
2) Tare the scale. Store the current weight in memory as a tare value, subtract the tare value from the weight and shows the net weight.
Entering a value using the keypad will store that value as the tare value;
3) Cycle through the functions or increase the active digit when setting value for parameters or other functions.
MOD/ ESC Key
1) Enter / Cancel the counting mode from weighing mode when “F3 KEY”=1;
2) Accumulate and print when “F3 KEY”=2;
3) “Hold” Function keep and cancel when “F3 KEY”=3;
4) Enter pre-tare value when “F3 KEY”=4;
5) Parameter setting for animal weighing when “F3 KEY”=5;
6) Cancel or quit from the operations.
FUN Key
1) Select or enter the function and save the setting values of parameters;
2) View unit weight, counts and total weight when counting mode ( “F3 KEY”=1);
3) View nos. of accumulated weight and total weight when “F3 KEY”=2;
4) Enter/Cancel animal weighing function when “F3 KEY”=5;
UNIT Key
1) When self-checking, press UNIT Key to set unit conversion coefficient.
2) Unit conversion when weighing.
SECTION 3 OPERATIONS
3.1 Power on/off
Press ON/OFF Key to power on the Indicator and the indicator self-checks, then goes into the weighing state.
3.2 Functions and parameters setting
When self-checking, press ZERO Key to enter parameter setting. Then display shows “F1 CLK”. Press TARE Key to move functions cycle.
Press FUN Key to enter the desire function or MOD Key to cancel or quite. See details on Section 4 Functions and Parameter Sections.
When self-checking, press TARE Key to enter “P8 CAL” calibration function.
When self-checking, press MOD Key to enter “P13 UT” unit setting.
When self-checking, press FUN Key to stop self-checking and it goes into the work state.
When self-checking, press UNIT Key to enter unit conversion coefficient setting.
3.3 Zero the scale
Press ZERO Key to set the zero point from which all other weighing and counting is measured. Usually this will only be necessary when the
platform is empty. When the zero point is obtained the ZERO indicator is ON.