Det-Tronics EQ3750ASH EQP Addressable Smoke & Heat (ASH) Module - Manual (Page 8)

Maintenance
To ensure reliable protection, it is important to check
the ASH Module on a regularly scheduled basis. The
frequency of checks is determined by the requirements
of the particular installation.
replaceMent parts
The ASH Module is not designed to be repaired in the
field. If a problem should develop, first carefully check for
proper wiring and programming. If it is determined that
the problem is caused by an electronic defect, the device
must be returned to the factory for repair.
Note
When replacing a device, be sure that all rocker
switches on the replacement are set the same
as the original device. Consult the settings
documented during system installation and setup
to determine proper settings for the new device.
Remove power before removing a device or
plugging in a replacement unit. When a device is
replaced with an identical device set to the same
address, configuration is done automatically.
DeVice repair anD return
Prior to returning devices, contact the nearest local
Detector Electronics office so that the Return Material
Identification (RMI) number can be assigned. A
written statement describing the malfunction must
accompany the returned device or component to
assist and expedite finding the root cause of the
failure.
Pack the unit properly. Always use sufficient packaging
material. Where applicable, use an antistatic bag as
protection from electrostatic discharge.
Note
Det-tronics reserves the right to apply a service
charge for repairing returned product damaged as
a result of improper packaging.
Return all equipment transportation prepaid to the factory
in Minneapolis.
orDering inForMation
When ordering, please specify:
EQ3750ASH Addressable Smoke and
Heat Module
Refer to the ASH Module Model Matrix for details.
MODEL DESCRIpTION
EQ3750 Addressable Smoke and Heat Module (ASH)
TypE MOUNTING OpTION
D Din Rail
p Panel Mount*
TypE AppROvAL AGENCy
W FM/CSA/ATEX/CE/IECEx
*U.S. Coast Guard approved, for use in Marine applications.
For additional information or for assistance in designing
a system to meet the needs of a specific application,
please contact:
Detector Electronics Corporation
6901 West 110th Street
Minneapolis, Minnesota 55438 USA
Operator: (952) 941-5665 or (800) 765-FIRE
Customer Service: (952) 946-6491
Fax: (952) 829-8750
Web site: www.det-tronics.com
E-mail: [email protected]
For information on ordering ASH Module loop field
devices, contact Detector Electronics.
95-8654
Specifications subject to change without notice.
Det-Tronics and Eagle Quantum Premier are registered trademarks or
trademarks of Detector Electronics Corporation in the United States, other
countries, or both. Other company, product, or service names may be
trademarks or service marks of others.
©Copyright Detector Electronics Corporation 2012. All rights reserved.
Detector Electronics Corporation
6901 west 110th Street • Minneapolis, Minnesota 55438 USA
Operator: (952) 941-5665 or (800) 765-FIRE
Customer Service: (952) 946-6491 • Fax (952) 829-8750
http://www.det-tronics.com • E-mail: [email protected]
R
EG
IST
ERE D BY UL AN
D B
SI
NO
. A2305 • NO. 2582 6
ISO 9001
RE GIS TERED FIRM
R EG IS TERED FIR M