Despatch LBB2-xxA/B-1 - Manual (Page 40)

O PERATION
LBB Series Oven Owner’s Manual
40 Version 15
Copyright © 2012 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.
SHif
PV shift value
(offset).
Moves the display temperature to the oven
temperature
0
Filt
PV filter.
If the process value is unstable to read, increasing this
value steadies the input signal.
0
out1
Output 1
function.
Function of the output. Must be set to Hi. for High Limit
control.
Hi.
o1.Hy
Output 1
hysteresis
value.
Amount of degrees the temperature must be below the
setpoint temperature before the High Limit can be reset 2.0
HSP.L
Lower limit of
HSP1.
Minimum temperature setting for the High Limit
0 (32 if  F)
HSP.H
Upper limit of
HSP1.
Maximum temperature setting for the High Limit 204 (400 if
 F)
out2
Second output Despatch does not use this function None
diSP
Normal display
format.
Used to select the display in normal condition:
 PV = Process Value
 SP! = High Limit Setpoint
 SAFE = The word “safe” in normal condition
PV
PuHi
Process value
high
Read-Only Data: Maximum process value since last
UNLOCK operation.
None
PuLo
Process value
low
Read-Only Data: Minimum process value since last
UNLOCK operation.
None
t.Abn
Abnormal time
Total accumulated minutes of abnormal conditions
since last UNLOCK operation.
None
5.4.8. Change High Limit instrument Display from Centigrade to
Fahrenheit
Warning!
Changing program parameters alters the function of the Control.
Proceed carefully and fully understand each parameter before
changing that parameter.
Configure the High Limit instrument for either °C or °F. Use the following steps to change High
Limit instrument from displaying °C to °F (and for changing back):
1. If on the High Limit instrument is lit, press and hold for four (4) seconds to
enable and .
2. Press and hold for four (4) seconds to enter Setup mode.
3. Press until
unit
displays.
4. Press or to display value.
5. Use or to move to the desired setting.
6. Press
to enter the value and advance to the next parameter.