Despatch Protocol Manager with Protocol Plus - Manual (Page 10)

Protocol Manager Software E-100
6
Software Setup
Configuring the Controllers
1. Use the keys on the faceplate of each Protocol Plus controller to set these
parameters. Consult Despatch Manual E98 for information on this process.
2. On each of the controllers, the following parameters must be defined in order
for the new control software to communicate with the controllers. Normal
conditions use the settings listed in parentheses in the Communication
Page in the Setup Mode of the controller.
Address (1 - 247) - A unique address must be assigned to each controller.
Make certain that controller addresses are known when setting up the
software.
NOTE that each of the multiple controllers must have a different address.
Communication mode (MUST be Modbus)
Baud rate (19.2 K)
Parity (none)