Dascom 2600 User Guide - Manual (Page 61)

Tally Dascom 2610
48
2. Static assignment using the operator panel:
◆ Press < Setup >, then < Menu >
.
◆ Press < Next > until the I/O selection appears. Select < I/O >.
◆ Press < Next > until the ETH-INT selection appears. Select < ETH-INT >, then< IP Addr >
◆ Enter the value for Octet 1by pressing < OCTET 1 >. Use the forward and backward
arrows to increment/decrement the number. When finished with each entry press
< Set > which will set the currently displayed value. To exit out without changing the value
press < Exit >. Enter the Octet 2 value in the same way, pressing < OCTET 2 >. To get to
Octet 3 and Octet 4, select < Next > and then select and < OCTET 4 >.
◆ Enter the default Gateway and Subnet mask in the same way. < Gateway > is available
from the screen you are returned to. Press < Next > to select < Subnet >.
◆ Enter the IP address get method under the selection . Select .
3. BOOTP IP address assignment:
◆ Press , then
.
◆ Press until the I/O selection appears. Select .
◆ Press until the ETH-INT selection appears. Select .
◆ Press until the IP Get M selection appears. Select Select
◆ Obtain the Ethernet MAC address by printing the “Current Settings” configuration page,
Turn off printer.
◆ Configure your BOOTP server with desired IP address and MAC address.
◆ Turn on printer.
◆ Verify that the printer network interface received an IP address by printing the “Current
Settings” configuration page or in the operator panel menu.