Dascom 2600 User Guide - Manual (Page 34)

Tally Dascom 2610
21
Detailed descriptions of the above functions:
◆ Speed
If LQ font is currently set in the configuration, lighting up of the
【 Speed 】 LED forces NLQ font
printouts; turning off 【 Speed 】 indicates LQ printouts.
If Draft is currently set in the configuration, lighting up of the 【 Speed 】 LED forces HS Draft printouts;
turning off 【 Speed 】 indicates Draft printouts.
◆ Setup Menu
See Chapter 5 for details.
◆ Clear Buffer and Reset
The printer has high capacity storage (buffer) to store the data from the host computer. Sometimes it is
required to halt the printing to clear a fault. Resuming the printing at this point may cause erratic
printouts because some of the un-processed data in the buffer may be truncated. Therefore, it is
recommended clearing the buffer after the recovery with following procedures: (Turning off the printer
is an alternative)
1) Terminate the print job in the host.
2) Press the
【 Online 】 key to bring the printer off-line. The printing will stop, but un-processed data
still resides in the buffer.
3) Hold 【 Online 】 and 【 Load/Eject 】 keys simultaneously. The buffer will be cleared and the printer
will automatically warm boot.
4) Probably you need to repeat step 2-3 times as the print job in the host spooler may be very large.