Dascom T2265+ Quick Installation Guide Cutting Device - Manual (Page 20)

Control panel operation Quick start guide
18
Press the Next key (4) several times until the Sync.Lab parameter appears in the
display.
Press the Sync.Lab key (3) .
Press the < (2) or > (3) key to switch the parameter to On.
Confirm the setting by pressing the Set key (1).
If you use paper without the required label on the back after activating the param-
eter Sync.Label, an error message Load error appears in the display, printing is
not possible.
If the printer cannot detect an existing label on the back of the paper, the param-
eter Pap.back can in test mode be set from “normal” to “dark”. You will find a
description of this parameter in the User Guide of your printer on the online
CD-ROM.
You must deactivate this parameter before removing the cut device. It only appears
in the advanced menu when the cut device is installed and therefore cannot be
switched off after removing the cut device, but remains active.
STOP
QSG2280+2380_Cutdevice_en.fm Seite 18 Donnerstag, 20. März 2008 3:22 15