Dascom T2265+ Quick Installation Guide Cutting Device - Manual (Page 15)

Quick start guide Control panel operation
13
ENGLISH
Control panel operation
It depends on the printer model, wether it supports the Single Sheet feature or not.
The display alternates between 2 notices and indicates the saved and active sheet
feeder (e.g.single sheet).
The alternating display reminds you that paper can be loaded via this sheet feeder.
However, since you want to use fanfold paper press the Setup button…
…and then the parameter button for Paperway (3).
Using the < (2) or > (3) buttons select the tractor in which the fanfold paperis lo-
cated (in our example in tractor 1).
Now confirm the paper path desired (in our example tractor 1) by pressing the
Set (1) button.
Online Single
Load
Load paper from
Single
Tractor1
Online
Setup
2 1 3 4
Set Exit
QSG2280+2380_Cutdevice_en.fm Seite 13 Donnerstag, 20. März 2008 3:22 15