Dascom T2265+ Quick Installation Guide Cutting Device - Manual (Page 16)

Control panel operation Quick start guide
14
An acoustic signal is produced in response and the set parameter is marked with
an asterisk (*) in the display.
The printer then switches back to the Setup menu. Press the Setup button again.
Now the printer is in Offline Mode.
Next transport the fanfold paper to the print position by pressing the Load (4)
button.
If there is any print data waiting at the interface and if the “active” paper is still in
park position, this is automatically transported to the current print position and the
printer is ready to print.
When the paper path is changed, the fanfold paper remains in the deactivated trac-
tor. The printer automatically returns this to the park position. Note that the set-
tings for the“Tractor” paper source in the “Paper” parameter group can be
defined separately for each tractor. Settings:
– Form length
– Setting the first print line
– Print head clearance setting (only printers with AGA = Off)
– Cut Position
If there should be any problems with paper feeding or paper transport, proceed as
described in the User Guide in the Troubleshooting section.
QSG2280+2380_Cutdevice_en.fm Seite 14 Donnerstag, 20. März 2008 3:22 15