Dascom T2265+ Quick Installation Guide Cutting Device - Manual (Page 17)

Quick start guide Control panel operation
15
ENGLISH
` Adjusting the cut position
The cut device will always cut the fanfold paper at the same set position. As a rule
this position should be just below the perforation of the fanfold paper.
Do not cut the paper above the perforation as the optimal paper flow may be
adversely affected by the paper remaining above the perforation.
Before setting the cut position, fanfold paper must be loaded and the printer set to
Online.
Proceed as follows to set the cut position:
Press the Setup button…
…and then choose the parameter Adjust (2).
Now press the Cut (4) button.
The printer switches to the precise cut position adjustment mode.
Please note that an automatical form feed is performed before each adjusting cut.
When the < (2) or > (3) buttons are pressed briefly, the paper is either moved for-
ward or backward. The individual values are displayed in increments of 1/72 of an
inch. The possible adjustment range is from -20/72" to +20/72".
STOP
QSG2280+2380_Cutdevice_en.fm Seite 15 Donnerstag, 20. März 2008 3:22 15