Condux Running Line Tensiometer - Manual (Page 7)

7
Maintain RLT with Care
21. Follow instructions for changing accessories. Inspect the RLTs plugs regularly, and if
damaged, have it replaced by an authorized service center. Inspect extension cords
periodically, and if damaged, replace them. Keep the RLT dry, clean and free from oil
and grease.
Stay Alert
22. Watch what you are doing, Use common sense. Do not operate the RLT when you are
tired.
Check for Damaged Parts
23. Before further use of the RLT, any damaged part should be carefully inspected to
determine that it will operate properly and perform its intended function. Check for
proper alignment of moving parts and verify that there is no binding. Ensure all mounting
hardware is securely fastened. Any damaged part should be properly repaired or replaced
by an authorized service center.
Avoid Unintentional Starting
24. Do not carry the RLT if it is plugged in, and be sure the switch is off before plugging in
the power cord.
Secure Work
25. Secure the conduit to its associated structure before pulling any cable through it.
RLT Operation:
Condux RLT’s are designed for safe operation, but these safety precautions should be practiced:
1. Stay clear of the area directly behind the puller while in operation
2. Use only 10 gauge 3 wire extension cords.
Rope Guidelines:
Four Safety Rules When Working With Rope
1.
RIGHT ROPE FOR THE JOB: Use adequate size rope recommended to accommodate
your pulling load.
2.
CORRECT HANDLING AND USAGE: Observe the recommended working load.
Make sure all pulleys, fairleads, etc. are proper size and free of grit and rust. Avoid knots
or severe bending that will reduce rope strength. Store rope in accordance with
manufacturer’s recommendations.
Table of Contents
SAVE THESE INSTRUCTIONS