Comelit MT 3451 FR - Manual (Page 22)

22
SELECT LANGUAGE
*OFF
ITALIANO
FRANCAIS
OK OK
SCROLL ESC
TRIPLE CALL
CONFIRMATION TONE
CODES BOOSTER
ANSWER WAIT TIME 60
VALUE IN SECS
10
SCROLL OK
ESC CANC
EN
4. Confi rm.
4. Confi rm.
2.2.1.5.3 S SERIAL
2.2.1.5.4 VOICE MESSAGES
A) ACTUATOR FUNCTION
Allows enabling/disabling of the actuator function on the
S serial line
3. Choose between:
3. Select a language to enable voice and visual messages on
the speaker module, or select OFF to disable voice and visual
messages on the speaker module.
1. Access programming mode, see page 17.
2. Select: settings/system parameters/speaker parameters/
advanced options/S serial/actuator function.
1. Access programming mode, see page 17.
2. Select: settings/system parameters/speaker parameters/
advanced options/voice messages.
YES
NO
Allows enabling/disabling of voice and visual messages
on the speaker module
4. Confi rm.
4. Confi rm.
4. Confi rm.
4. Confi rm.
A) TRIPLE CALL
2.2.1.5.5 CALL
Allows enabling/disabling of the triple call function
3. Choose between:
1. Access programming mode, see page 17.
2. Select: settings/system parameters/speaker parameters/
advanced options/call/triple call.
YES
NO (default)
B) CONFIRMATION TONE
C) CODES BOOSTER
C) ANSWER WAIT TIME
Allows enabling/disabling of the the call confi rmation
tone
Allows enabling/disabling of the call codes booster
Allows setting of the call answer wait time
3. Choose between:
3. Choose between:
3. Enter the value in seconds.
1. Access programming mode, see page 17.
2. Select: settings/system parameters/speaker parameters/
advanced options/call/confi rmation tone.
1. Access programming mode, see page 17.
2. Select: settings/system parameters/speaker parameters/
advanced options/call/codes booster.
1. Access programming mode, see page 17.
2. Select: settings/system parameters/speaker parameters/
advanced options/call/answer wait time.
YES (default)
NO
YES
NO (default)
D) VIEW
Allows viewing of the speaker module call parameters
» Reproduces the speaker module call parameters
1. Access programming mode, see page 17.
2. Select: settings/system parameters/speaker parameters/
advanced options/call/view.
2.2.1.5.6 SELF IGNITION
Allows enabling/disabling of self-ignition
3. Choose between:
1. Access programming mode, see page 17.
2. Select: settings/system parameters/speaker parameters/
advanced options/call/self ignition.
YES (default)
NO
4. Confi rm.
1. Access programming mode, see page 17.
2. Select: settings/system parameters/speaker parameters/
advanced options/default settings.
Used to restore the default settings:
2.2.1.5.7 DEFAULT SETTINGS
4. Confi rm.
3. Choose between:
YES
NO
De-misting heating element = disabled
Audio-visual messages = disabled
Door lock command on SE in AC
Door lock time = 2 sec + tone disabled
C.NC.NO relay in parallel with SE
Door lock-release always enabled
Actuator function on S serial line = disabled
Answer wait time = 60 sec
Conversation time = 90 sec
Self-ignition = enabled
Confi rmation tone on user call = enabled
Reset wait time = 10 sec
Send call = single
Control of internal units connected to speaker module = up to 70
System mode = Simplebus