Comelit MT 3451 FR - Manual (Page 18)

18
CODE:
_ _ 2
SKIP OK
ESC CANC
INDIRECT CODE:
_ _ _ _ _ 2
SKIP OK
ESC CANC
CODE:
_ _ _ _ _ 2
SKIP OK
ESC CANC
ENTER PASSWORD:
_ _ _ 3416
SKIP OK
ESC CANC
PASS KEY
SKIP OK
ESC CANC
ENTER NAMES
CHANGE NAMES
DELETE NAMES
CLEAR ALL NAMES
OK OK
SCROLL CANC
M_
OK
ESC CANC
M_
OK
ESC CANC
MARIO ROSSI_
OK OK
SCROLL CANC
ENTER NAMES
CHANGE NAMES
DELETE NAMES
CLEAR ALL NAMES
OK OK
SCROLL CANC
EN
ONLY WITH "INDIRECT CODE" ENABLED (see section 2.5)
4. Press to confi rm.
5. Enter the "call code" and press to confi rm.
6. Enter the "indirect code" and press to confi rm.
or:
or:
press to skip entry.
press to skip entry.
IN SIMPLEBUS MODE
IN SIMPLEBUS TOP MODE (see "2.5 Call management")
» The confi rmation message "KEY DETECTED" "COLOUR"
will appear on the display.
» The red and green LEDs fl ash alternately to indicate that the
device is waiting for a key to be registered.
ONLY WITH "ACCESS CONTROL" ENABLED (see section 2.6)
ONLY WITH "INDIRECT CODE" ENABLED (see section 2.5)
or:
press
to skip entry.
or:
press to skip entry.
7. Enter the password and press to confi rm.
8. Move the key over the RFID sensor.
1.1.2 CHANGE NAMES
1.1.3 DELETE NAMES
"Change names" can be used to change a name and call code,
plus the indirect code associated with it.
"Delete names" can be used to remove a name and the data
associated with it.
1. Access programming mode, see page 17.
2. Select data management/names/change names by scrolling
through the menu using and pressing or to confi rm.
1. Access programming mode, see page 17.
2. Select data management/names/delete names by scrolling
through the menu using and pressing or to confi rm.
not available if the call mode is IMMOTEC STANDARD or
IMMOTEC INDIRECT (see section 2.5)
3. Enter the name (full name or just the fi rst letter).
3. Enter the name (full name or just the fi rst letter).
4. Press to start searching.
5. Scroll using and/or press or to confi rm the name
you wish to change.
6. Change the name and press to confi rm.
7. Change the "call code" and press to confi rm.
8. Change the indirect code and press to confi rm.
9. Press to exit.
The password must be at least 4 characters long