Comark RF500A User Manual
Page 57
56
Appendix A – Gateway Connection via RJ45 Cross-Over Ethernet Cable
1.
Set up your computer temporarily with a fixed IP address using the instructions given in Appendix B - Setting a
Fixed IP Address.
2.
Connect the cross-over Ethernet cable between computer and RJ45 jack on the Gateway.
3.
Configure the RF500A Gateway as in Gateway Commissioning. {Page 17}
4.
Remove the cross-over Ethernet cable after the Gateway has reset. (See Gateway Reset {Page 11})
5.
Using Appendix B - Setting a Fixed IP Address as a guide, restore the computer network settings back to as
existed previously.
6.
Connect both the PC and RF500 Gateway to the LAN using regular Ethernet patch leads.
7.
Verify that a connection can be made to the Gateway by following the steps in “Viewing the Gateway Login
Page” {Page 19} but using the newly configured IP Address instead of 192.168.25.220.