CiDRA SONARtrac Quick Start - Manual (Page 26)

4.4 HART Commands
The following is a list of supported HART commands.
Command Name HART 5 or 6
Supported
by CiDRA
Universal Commands
0 Read unique identifier HART 5 & 6 YES
1 Read primary variable HART 5 & 6 YES
2 Read current and percent of range HART 5 & 6 YES
3 Read current and four (predefined) dynamic variables HART 5 & 6 YES
4 Reserved HART 5 & 6 YES
5 Reserved HART 5 & 6 YES
6 Write polling address HART 5 & 6 YES
7 Read loop configuration HART 6 YES
8 Read dynamic variable families HART 6 YES
9 Read Device Variables with Status HART 6 YES
11 Read unique identifier associated with tag HART 5 & 6 YES
12 Read message HART 5 & 6 YES
13 Read tag, descriptor, date HART 5 & 6 YES
14 Read PV sensor information HART 5 & 6 YES
15 Read output information HART 5 & 6 YES
16 Read final assembly number HART 5 & 6 YES
17 Write message HART 5 & 6 YES
18 Write tag, descriptor, date HART 5 & 6 YES
19 Write final assembly number HART 5 & 6 YES
20 Read long tag HART 6 YES
21 Read unique ID associated with long tag HART 6 YES
22 Write long tag HART 6 YES
Common Practice Commands
33 Read transmitter variables HART 5 & 6 YES
34 Write damping value HART 5 & 6 YES
35 Write range values HART 5 & 6 YES
36 Set upper range value (= push SPAN button) HART 5 & 6 YES
37 Set lower range value (= push ZERO button) HART 5 & 6 YES
38 Reset "configuration changed" flag HART 5 & 6 YES
39 EEPROM control HART 5 & 6 NO
40 Enter/exit fixed current mode HART 5 & 6 YES
41 Perform device self- test HART 5 & 6 YES
42 Perform master reset HART 5 & 6 YES
43 Set (trim) PV zero HART 5 & 6 YES
44 Write PV units HART 5 & 6 YES
45 Trim DAC zero HART 5 & 6 YES
46 Trim DAC gain HART 5 & 6 YES
47 Write transfer function HART 5 & 6 YES
48 Read additional device status HART 5 & 6 YES
49 Write PV sensor serial number HART 5 & 6 YES
Copyright © 2007 CiDRA Corporation Page 4-6
20984-01 Rev 01