chiliGREEN W760K - Manual (Page 178)

D - 2 Operating System Setup
D
Operating System Setup
If you are installing new system software, or are re-configuring your computer for a different system, make sure you
configure the appropriate OS setting in the BIOS before installing a new operating system.
1. Start-up the computer and press <F2> to enter the BIOS.
2. Go to the Advanced menu, select “Installed O/S” and make sure the appropriate operating system is selected.
3. Go to the Exit menu and select “Exit Saving Changes” (or press F10 and select “Yes” then press Enter) and
press Enter to exit the BIOS and reboot the computer.
Figure D - 1 - Advanced BIOS Menu
Main A Advanced Security Boot Exit
F1 Help Select Item -/+ Change Values F9 Setup Defaults
Esc Exit Select Menu Enter Select Sub-Menu F10 Save and Exit
Item Specific Help
Advanced
Select the operating
system installed
on your system which
you will use most
commonly.
Note: An incorrect
setting can cause
some operating
systems to display
unexpected behavior.
PhoenixBIOS Setup Utility
Advanced Chipset Control
Installed O/S: [ WinXP ]
Legacy USB Support: [Enabled]
Boot-time Diagnostic Screen: [Disabled]
Reset Configuration Data: [No]
Power on Boot Beep: [Disabled]
Battery Low Alarm Beep: [Disabled]