2 3 1 front and rear panels – C.B.S. Scientific DGGEK-4801 User Manual
Page 5
8
9
www.cbsscientific.com
Cipher DGGE Instructions 2/28/14
Front View
Rear View
1. Display
11.
Pump Speed Switch
2. Preset Temperature Buttons
12.
Identification Label
3. Safety Set Reset Button
13.
Pump Inlet
2
4. Safety Set Indicator Knob
14.
Reservoir Purge
2
5. Cooling Light
1
15.
Pump Outlet
2
6. Power ON / OFF Button
16.
AC Input
7. Heating Light
17.
Circuit Breaker / AC Power Switch
8. °F Light
9. Select/Set Knob (Push to set, turn to adjust)
10. °C Light
1
Present on Refrigerating/Heating models only
2
Built in on reservoir models only
1
2
3
4
6
5
7
9
8
10
11
12
13
17
14
16
15
2 3 Operating Heater/Stirrer/By-Pass Pump (Controller)
1) Attach power cord to heater/stirrer and plug into wall outlet.
(comes factory-mounted onto DGGE tank)
2 3 1 Front and Rear Panels
1. Temperature Sensor
2. Pump Shaft and Impeller
3. Pump Outlet Nozzle
1
4. Over-Temperature Sensor
5. Heater Coils
1
Rotates on Immersion Circulators
Temperature Stability
±0.05°C
Readout Accuracy
±0.5°C
Over-Temperature Protection
Yes, user-adjustable
Low-Liquid Protection
Yes
Heater
1100W – 115V,
1600 W – 240V
Pump Speeds
2-speed, 9 liters per minute or 15 liters per minute
Environmental Conditions:
Indoor Use Only
Over Voltage: Category ll
Maximum Altitude: 2000 meters
Operating Ambient: 5° to 30°C
Relative Humidity: 80% for temperatures to 30°C
Pollution Degree: 2
Class 1: Residential, Commercial, Light Industrial
Class 2: Heavy Industrial
Locate the Circulator on a level surface, free from drafts and out of direct sunlight. Do not place it
where there are corrosive fumes, excessive moisture, high room temperatures, or excessive dust is
present.
Refrigerating/Heating Circulators must be a minimum of four inches (102mm) away from walls or
vertical surfaces so air flow around the unit is not restricted.
To help prevent voltage drops, position the Circulator as close as possible to the power distribution
panel and a properly grounded outlet. The use of an extension cord is not recommended.
Warning: These units are equipped with over-temperature protection (Safety Set). A low liquid level
or failure to set the Safety Set and properly immerse the heater may result in heater burnout and triac
failure. While operating, do not allow the heater to contact any potentially flammable materials, such
as plastic racks or sides of plastic tanks, as a fire hazard may result.
5
3
1
2
4
2 3 2
Controller Assembly
2 3 3
Controller Specifications
1. Temperature Sensor
2. Pump Shaft and Impeller
3. Buffer By-Pass Tubing Adapter
4. Over-Temperature Sensor
5. Heater Coils
1.
5.
4.
3.
2.