Online manual not for resale purposes – BLITZ Toyota Yaris Compressor System User Manual

Page 19

WARNING: All images and text in this manual is the property of Blitz Co., Ltd. (Japan).
No parts of this manual may be reproduced, stored in retrieval systems, or transmitted in any way
without prior written permission of Blitz Co., Ltd. (Japan).

10. Inlet Pipe Stay

⑧

Hex

Bolt

⑮

asher

30) Install the blow by hose and the master back

hose using two 31.Clamps.

※

Cut the blow by hose and the master back
hose to the appropriate length since it will
be slightly long.

※

Adjust and cut the blow by hose where it
becomesφ9 to fit the nipple; since the hose
is a

variant type from

19-φ9.

25) Install temporarily the 10.Inlet Pipe Stay

where the transmission docking bolt was
attached using one ⑧Hex Bolt.

26) Install temporarily the 4.Inlet Pipe using the

29.Silicone Hose and two 30.Hose Bands.

27) Install the 4.Inlet Pipe to the 10.Inlet Pipe Stay

using two ⑩Cap Bolts.

28) Fully tighten the 10.Inlet Pipe Stay from “step

25”.

29) Fully tighten the 30.Hose Bands from “step

26”.

29.Silicone Hose

30.Hose

Band

4.Inlet Pipe

10. Inlet

Pipe
Stay

Cut to Appr

opri

ate

Length

Blow by H

Master Back
Hose

31. Clamp

Online Manual Not For Resale Purposes