Barranca Diamond MK-5005S Block Saw User Manual
Page 7
7
Sawing and drilling generates dust. Excessive airborne particles may cause irritation to eyes, skin
and respiratory tract. To avoid breathing impairment, always employ dust controls and protec-
tion suitable to the material being sawed or drilled; See OSHA (29 CFR Part 1910.1200). Diamond
Blades improperly used are dangerous. Comply with American National Standards Institute Safety
Code, B7.1 and, Occupational Safety and Health Act covering Speed, Safety Guards, Flanges,
Mounting Procedures, General Operating Rules, Handling, Storage and General Machine Conditions.
HaZaRD SYMBolS
NEVER touch electrical wires or components while the engine is running. Exposed,
frayed or worn electrical wires can be sources of electrical shock which could cause
severe injury or burns.
Keep hands, feet, hair, and clothing away from all moving parts to prevent injury. Never
operate the motor with covers, shrouds, or guards removed.
NEVER tamper with the governor components or settings to increase the maximum
speed. Severe personal injury and damage to the motor or equipment can result if oper-
ated at speeds above maximum.
Do NoT expose to rain or use in damp locations.
waRNING
RoTaTING PaRTS
ElEcTRIcal SHocK
oVER SPEED
Do NoT EXPoSE To RaIN
MK-5005S
SaFETY
(
(
)
)
on
on
accIDENTal STaRTS
Before starting the engine, be sure the ON/OFF switch is in the “OFF” position to prevent
accidental starting. Place the ON/OFF switch in the OFF position before performing any
service operation.