Barranca Diamond MK-5005S Block Saw - Manual (Page 16)

16
connecting the water Pump
water Pump Setup for operation
1. To prevent the possibility of electrical shock, the MK-5005S MUST be de-ener-
gized when connecting the Water Pump.
2. To prevent the possibility of electrical shock, use only MK Diamond qualified
replacement parts.
To prevent pump damage, the Water Pump must be disconnected if cutting with a
Dry Blade.
(B)
Connect the Water Pump
power cord to the connection
found on the side of the motor
(A)
Ensure the ON/OFF Switch
is in the OFF position
(G)
Inspect the Pump Assembly for
damage – ensure the cord
is free of cracks or cuts
waRNING
NoTE:
NoTE:
The Water Pump can be setup for operation in two ways, External Water Source or Re-circulation.
If using a Dry Blade for operation, DO NOT connect the Water Pump.
MK-5005S SETUP