Barranca Diamond MK-5005S Block Saw - Manual (Page 18)

18
1. While the MK-5005S can cut the materials listed earlier in this document, it is
specifically designed to cut concrete masonry. Cutting another material with
the MK-5005S will reduce the life of the Diamond Blade.
2. Due to the material being cut, the Diamond Blade should not require dressing.
If dressing is required, use a soft stone such as sandstone.
DO NOT FORCE the blade to cut, it will do the job better and safer at the rate
for which it was designed.
(A)
Set edge of Cutting Guide to
desired cut length on Ruler/Stop
(A)
Ensure the ON/OFF Switch
is in the OFF position
(B)
Connect the MK-5005S to
the proper power source
Power connection
cutting Setup
NoTES:
caUTIoN
MK-5005S oPERaTIoN
(B)
Set material against adjustable
Cutting Guide and Ruler/Stop