Barranca Diamond MK-5005S Block Saw - Manual (Page 30)

30
All four (4) movable Cutting Table, Roller Wheels should be replaced at the same time
(MK Diamond Part No. – 152493).
When installing the Retaining Bolt, do not “cross-thread” and DO NOT over tighten the Nut.
(D)
Obtain Wheel replacement
parts (See parts list)
(E)
Install Wheel/Washer Assembly
into movable Cutting Table
(F)
Install Roller Wheel
Retaining Nut and tighten.
Rotate clockwise to tighten
(A)
Place movable Cutting Table on
workbench with Roller Wheels Up
(B)
Remove Roller Wheels
(C)
Clean holes to prepare for instal-
lation of new Roller Wheels
(G)
Lubricate Roller Wheels
(H)
Install movable Cutting Table
Movable cutting Table wheel change-out
NoTE:
NoTE:
MK-5005S TRoUBlESHooTING