Barranca Diamond MK-5005S Block Saw - Manual (Page 17)

17
External water Source
Re-circulation
(A)
Remove the Drain Plug
(B)
Place the Water Pump in an
external container
(C)
Fill the external container until
water completely covers the
Water Pump intake
(D)
Locate the Water Basin
Drain Connection (located in the
back of the Water Basin)
(A)
Ensure the Drain Plug is
installed in the Water Basin
(B)
Place the Water Pump in
the back of the Water Basin
(C)
Fill the Water Basin until water
completely covers the
Water Tank intake
(E)
Install an external drain line onto
the Drain Connection
NoTE:
NoTE:
NoTE:
This is the preferred method of cooling. This method may add as much as twenty (20)
percent to the life of the blade.
Follow all applicable Federal State and Local laws for the proper disposal of waste
water.
When using the re-circulation method, the water should be changed often for longer
pump life.
MK-5005S SETUP