Barranca Diamond MK-5005S Block Saw - Manual (Page 12)

12
11.2010
MK-5005S BLOCK SAW OWNERS MANUAL
PARTS LIST & OPERATING INSTRUCTIONS
www.mkdiamond.com
Caution: Read all safety and operating instructions before using this equipment. This parts list MUST accompany the equipment at all times.
Revision 101 Manual Part# 158769
MK-5005S Movable Cutting
Table
Adjustable
Cutting Guide
Electric
Water Pump
Pump
Discharge Fitting
Blade
Wrench
Drain
Plug
Owner’s
Manual
Pump
Manual
Warranty
Card
Your MK-5005S has been shipped from the factory thoroughly inspected. Only minimal assembly is
required. If not already done, remove the MK-5005S from the pallet and place it on a flat surface
using a forklift.
Remove the accessories from the Water Basin and place along side the MK-5005S.
The MK-5005S weighs approximately four hundred forty-five (445) pounds (without the movable Cut-
ting Table).
Do not attempt to move the MK-5005S without a forklift.
Place the Cutting Head in the DOWN position, and remove the movable Cutting Table
when transporting the MK-5005S.
Due to its solid construction, the MK-5005S may only be transported with a forklift. Position the Cut-
ting Head in the DOWN position, remove the movable Cutting Table, and transport the saw using the
eight (8) lift points positioned strategically around the base. Use tie downs when transporting the saw.
waRNING
NoTE:
UNPacKING
coNTENTS
MK-5005S coNTENTS
TRaNSPoRT
Tie Down
Lift Points
In the containers, you will find one (1) MK-5005S, one (1) movable cutting table, one (1) adjustable
cutting guide, one (1) electric water pump, one (1) pump discharge fitting, one (1) blade wrench, one
(1) drain plug, one (1) owner’s manual, one (1) pump manual and one (1) warranty card.