Barranca Diamond MK-5005S Block Saw - Manual (Page 26)

26
Perform the following after initial purchase and operation of the MK-5005S.
The following maintenance should be performed following each use. Use light oil, such as WD-40
or 3 in 1 when lubricating parts.
(A)
Check and adjust V-belt
tension following first forty-eight
(48) hours of operation (See V-
belt Inspection page 32)
(A)
Ensure the ON/OFF switch
is in the OFF position
(B)
Lubricate lower pivot points
(C)
Lubricate upper pivot points
(D)
Clean and lubricate all spring
assemblies
(E)
Lubricate the Roller
Wheel Assemblies
New Maintenance
Maintenance Following Use
MK-5005S MaINTENaNcE