Mk-170 tile saw setup – MK Diamond MK-170 User Manual
Page 17

17
water Pump Preparation
(A)
Install Water Pump Discharge
Fitting
(D)
Fill the Water Pan with clean
water (this should be done peri-
odically during cutting).
(G)
Connect the Water Pump pow-
er cord to the connection found
on the back of the motor.
(B)
Remove the Cutting Table from
the Water Pan
(E)
Place the Water Pump in the
Water Pan-ensure the pump
suction is covered.
(C)
Press the end of the Cooling
Transfer Tube onto the water
Pump Discharge Fitting
(F)
Install the Cutting Table; ensure
the pump power cord is sealed
in the slot behind the Post.
MK-170 Tile Saw SeTUP
1. To prevent the possibility of electrical shock, the MK-170 MUST be
de-energized when preparing the Water Pump for operation.
2. To prevent the possibility of electrical shock, use only MK Diamond qualified
replacement parts.
waRNiNG
- MK-770 (41 pages)
- MK-770 EXP (46 pages)
- MK-660 (44 pages)
- MK-470 (12 pages)
- MK-377 (36 pages)
- MK-370 (36 pages)
- MK-370 EXP (52 pages)
- MK-145 (32 pages)
- MK-145 220 Volt (32 pages)
- MK-101 (52 pages)
- MK-101 (56 pages)
- MK-101-24 (52 pages)
- MK-101-24 (56 pages)
- MK-101 Pro / Pro24 (56 pages)
- MK-101 Tracker (45 pages)
- MK-101Pro24 JCS (60 pages)
- MK-101 JCS Rental (51 pages)
- MK-101 Lowes (56 pages)
- MK-101 Lowes (52 pages)
- MK-100 (44 pages)
- MK-100 (52 pages)
- MK-100 Tracker (46 pages)
- MK-100 JCS (49 pages)
- TX-3 (52 pages)
- Saw Tent (2 pages)
- MK-112 (28 pages)
- MK-1070 (22 pages)
- MK-212 (52 pages)
- MK-1590 (36 pages)
- MKDX Profile Milling Machine (40 pages)
- MK-EZ Profile Milling Machine (36 pages)
- MK-1503SS (24 pages)
- MK-1080 (44 pages)
- MK-1080 (1 page)
- MK-1080 (3 pages)
- MK-1280 Gas Saw (48 pages)
- MK-1280 Electric Saw (40 pages)
- MK-1280 Rolling Cart (4 pages)
- MK-1270 (Shindaiwa) (28 pages)
- MK-2000 Electric Saws (52 pages)
- MK-2000 Gas (60 pages)
- MK-5005S (56 pages)
- MK-5000 Gas Saws (56 pages)
- BX-3 (36 pages)