Auto Meter 201975 - Manual (Page 2)

OIL PRESSURE
The oil pressure gauge is installed directly above the steering
column.
1. Use only the installation components provided with the
gauge.
2. Do not cut hole in firewall. Use hole already provided.
3. Refer to the Mechanical gauge installation (Pressure
Gauges) for installing the oil gauge.
4. Install the 90 o brass fitting on the back of the gauge using
Teflon tape. Make sure the fitting is tight and pointing down
and away from the bracket and case studs.
5. Instead of nylon tube use #4 stainless braided hose
(also known as –4AN) to the brass adapter. ONLY USE
STAINLESS STEEL BRAIDED HOSE FOR COUPLING
THE GAUGE TO THE ENGINE.
6. Position the hose away from hazardous moving parts or hot
engine components to the point of attachment.
FUEL PRESSURE
The fuel pressure gauge is installed above and to the right of
the speedometer (see drawing). WARNING: DO NOT INSTALL
ELECTRICAL GAUGES IN THIS DASHBOARD/HOLE LOCATION.
The wires and electrical connections on the back of the gauge will
short out on the steel support tubes on the cobra frame.
1. Use only the installation components provided with the gauge.
2. Do not cut hole in firewall. Use hole already provided.
3. Refer to the Mechanical gauge installation (fuel pressure
Gauges) for installing the fuel pressure gauge.
4. Position the hose away from hazardous moving parts or hot
engine components to the point of attachment.
AMMETER
The ammeter gauge is installed directly above the speedometer.
1. Use only the installation components provided with the
gauge.
2. Do not cut hole in firewall. Use hole already provided.
3. Refer to the short sweep electric gauge installation (Ammeter
Gauge) for installing the ammeter gauge.
FUEL LEVEL
The electric fuel level gauge can be installed instead of
the fuel pressure gauge, but it cannot be installed in the same
location. To avoid possible fire hazards, if the electric fuel level
gauge is desired, mount it in the dash above and to the left of the
speedometer. Move the water temperature gauge to above and to
the right of the speedometer. WARNING: DO NOT INSTALL THE
FUEL LEVEL OR AMMETER IN HOLE DESIGNATED FOR THE
FUEL PRESSURE. The wires/terminals on the back of the gauge
will short out on the steel support tubes and cause a fire hazard.
1. Use only the installation components provided with the gauge.
2. Do not cut hole in firewall. Use hole already provided.
3. Refer to the short sweep electric gauge installation (Fuel
Level Gauge) for installing the fuel level gauge.
4. Use # 8 Ring terminals. Ring terminals must be both crimped
and soldered to the circuit wires. This will avoid inaccurate
gauge readings from increased resistance in the connection.
5. This gauge is designed to work with a gas tank sender that
has 33 ohms when full and 240 ohms when empty.
VOLTMETER
The voltmeter gauge is installed directly above the speedometer.
1. Use only the installation components provided with the gauge.
2. Do not cut hole in firewall. Use hole already provided.
3. Refer to the short sweep electric gauge installation (voltmeter
level Gauges) for installing the voltmeter gauge.
4. WARNING: DO NOT CONNECT THE VOLTMETER
ACROSS THE BATTERY.
5. Use # 8 Ring terminals. Ring terminals must be both crimped
and soldered to the circuit wires. This will avoid inaccurate
gauge readings from increased resistance in the connection.
FOR SERVICE CONTACT: AUTO METER PRODUCTS Inc. 413 West Elm Street, Sycamore, IL 60178 USA
(815)899-0801 or Email us at [email protected]
2650-1193 10/16/06