Atop Technology AW5500 User manual - Manual (Page 39)

Atop Industrial Wireless Access Point
AW5500
User Manual V. 1.3
34
4.4.4 WPS Settings
This option is available only when AW5500 is running in the Regular AP mode. WPS stands
for Wi-Fi Protected Setup, PBC stands for Push Button Configuration. WPS needs to be
enabled before you can Start WPS PBC. To use this feature, first trigger the WPS process in
AW550 by pressing the WPS PBC button and click on the WPS PBC button on SW550X’s UI
or other WPS methods designated by a WPS compatible device, Figure 4.14. After the Start
WPS PBC button is pressed, WPS would be triggered and the AW5500 will wait for 120
seconds for a WPS compatible device to associate with it automatically.
Figure 4.14
Note that since AW5500 only supports the “Configured” mode of WPS, the following wireless
settings need to set manually before the device would enter the WPS state:
Table 4.6
Operation Mode Regular AP
Basic Settings
SSID User Define
Wireless Mode User Define
Security Settings
Authentication WPA-PSK or WPA2-PSK
Encryption TKIP or AES
Passphrase User Define
*Again, TKIP is not covered in the 802.11n standard and the wireless rate would be limited to
54 Mbps.