APG PG10 user manual User Manual

Page 36

PG10

Rev. B, 6/11

Automation Products Group, Inc.

APG...Providing tailored solutions for measurement applications

Tel: 1/888/525-7300 • Fax: 1/435/753-7490 • www.apgsensors.com • [email protected]

Sensor Number (SENNUM):
Sets the PG10’s sensor address number for the RS-485 Modbus
communications. Options: 1 Stop bit, 2 Stop bits

Setting the number of Stop Bits:

Step 1: Press to enter the main setup menu.

Step 2: Press or to cycle through the options until COMM is

displayed.

Step 3: Press to access the Communications settings menu.

Step 4: Press or to cycle through the options until SENNUM is

displayed.

Step 5: Press to access the Sensor Number setting. A 3-digit number will

appear with the fi rst digit fl ashing.

Step 6: Press or to change the value of the fi rst fl ashing digit.

Step 7: Press to accept the value of the fl ashing digit and advance to the

next digit......repeat steps 6 and 7 until the desired sensor address

number is entered. The PG10 will automatically return to the

Communications menu once the last digit is entered.

MODE

ENTR