Anchor BANDSHELLS 40X40 - Manual (Page 2)

40’ x 40’ BANDSHELL PACKING LIST
DESCRIPTION: Quantity
Three (3) sections of bandshell fabric in canvas bags. Marked FRONT, MIDDLE, And REAR. 3
30” Steel Stake (for Base plates ) 8
Front Pole, 32’-4” long aluminum 2
Rear Pole, 28’-4” long aluminum 2
Pole Base Plate with Bolt & Nut 4
1’-9 1/4” Cable (3/8”) with 1’-0” turnbuckle and shackle Guy (Point A) 2
1’-3 3/4” Cable (3/8”) with 1’-0” turnbuckle and shackle Guy (Point B) 2
2’-2 1/2” Cable (3/8”) with 1’-0” turnbuckle and shackle Guy (Point D) 2
1’-5 3/4” Cable (3/8”) with 1’-0” turnbuckle and shackle Guy (Point E & F) 4
2’-3 1/2” Cable (3/8”) with 1’-0” turnbuckle and shackle Guy (Point G) 2
28’-11 3/8” (3/8”) Cable with 1’-0” turnbuckle and shackle Guy (Point I) 2
(1) 7/8” Shackle, (2) Pear Rings, (4) 1’-0” Turnbuckles for Double Guy (Point C) 2
(1) 7/8” Shackle, (2) 12’-4” Cables (5/8”, (4) 1’-0” Turnbuckles for Double Guy (Point H) 2
The installation of the Anchor Bandshell should be performed/supervised by knowledgable tent
installers with a clear understanding of safety issues as well as the methods of anchoring.
The installer/owner should read the assembly instructions completely prior to any installation.
Special attention should be given to anchoring! It is the responsibility of the installer/owner to
assure proper anchoring at all points and that the anchoring system meet the load requirements
defined on the blue print information included (see page 9). Additionally, blue prints are avail-
able for all “Certified” Bandshell orders. CAUTION
TOOLS REQUIRED
(NOT PROVIDED WITH BANDSHELL)
DESCRIPTION: Quantity
100’ Tape Measure 2
Pole Stand (Tripod Type) 4
Pull Rope Assembly 2
Support Guy 2
36’-0” Take-up Double Block & Tackle 2
20’-0” Pole 4
Drop Cloths (approx. 40’ x 50’) 3
Drop Cloths (approx. 15’ x 40’) 3
Stake or Anchor Installation Tools (Manual or Power Drive Anchor Installers) As Required
NOTE: Tools may be purchased from Anchor Industries Inc. or supplied by installer.
1