Anchor BANDSHELLS 40X40 - Manual (Page 11)

Photo 15
DISASSEMBLY INSTRUCTIONS
1. DISASSEMBLY IS THE REVERSE OF ASSEMBLY, EXCEPT AS FOLLOWS:
A. BE SURE A-FRAME POLES ARE SECURELY FASTENED TO RING ON PULL ROPE.
THEY WILL BE LIFTED UP DURING THE FIRST STEPS AND MAY COME LOOSE.
B. THE BLOCK & TACKLE SHOULD BE PUT IN PLACE WITH A MINIMUM OF TAKE-UP.
C. CHECK SUPPORT ROPE, IT SHOULD NOT BE VERY TIGHT.
D. TO START THE POLES DOWN, RELEASE THE GUYS AT POINT I AND PUSH THE
FRONT POLES BACK (BE SURE THE BLOCK & TACKLE IS TIED OFF).
E. BE SURE MATERIAL IS NOT CAUGHT AS YOU LET THE POLES DOWN ONTO
STANDS.
2. CARE AND STORAGE:
A. ALWAYS MAKE ABSOLUTELY SURE FABRIC IS DRY BEFORE STORING.
B. STORE IN PROVIDED SACKS IN A COOL, DRY AREA - AWAY FROM RODENTS.
RODENT PROTECTION MAY BE NECESSARY IF THEY ARE PLENTIFUL. KEEP OFF
FLOOR.
C. CLEAN FABRIC WITH MILD LAUNDRY DETERGENT AND A SOFT BRISTLED BRUSH.
A HIGH PRESSURE SPRAYER MAY BE USED, BUT KEEP THE NOZZLE 18” AWAY
FROM FABRIC. DO NOT USE STEAM CLEANERS.
D. SAND AND PAINT THE STEEL BASE PLATES, STAKES AND TOP OF POLES BEFORE
STORING TO ELIMINATE FUTURE RUSTING.
E. FOR SAFE BANDSHELL PERFORMANCE, CONDUCT REGULAR INSPECTION OF ALL
CABLES, WEBS, HARDWARE AND STRUCTURAL COMPONENTS. REPLACE
COMPONENTS IF THEY ARE WORN OR QUESTIONABLE.
10