Anchor NAVI-TRAC 30 WIDE GABLE-END - Manual (Page 12)

12
INSTALLING PURLINS AND RIDGE BARS
COMPLETING THE 1ST BAY
IN 20’ MID BAYS, INSTALL A SUPPORT PURLIN
BETWEEN THE EAVE AND THE PURLIN AT THE MID-
RAFTER LOCATION. THIS SUPPORT WILL BRACE
AGAINST INWARD DEFLECTION OF THE EAVE BAY
THAT COULD OTHERWISE RESULT IN WATER POND-
ING IN THE 20 FT BAY.
USE SAME TECHNIQUE AND THE
LONG LIFTING POLE WITH CRADLE
TO INSTALL THE PURLINS AND
RIDGE EAVE BAR (AT THE PEAK)
REMOVE CROSS-CABLE FROM 2ND BEAM
COMPLETING THE TOP FRAME INSTALLING GABLED END
FRAME
REPEAT PREVIOUS STEPS UNTIL
ALL BEAMS ARE VERTICAL AND
BOTH END BAYS ARE X-CABLED,
AS SHOWN.
INSTALL GABLED END FRAME. MAKE CONNECTIONS
IN THE ORDER SHOWN.
UG-15 1
EW-15
BFW
15’
2 3 4 5
6