Allen&Heath GS3000 - Manual (Page 7)

GS3000 U SER G UIDE 7
P OWER S UPPLY
Refer to the SAFETY WARNING on page 3 of this User Guide. Read and understand the warnings
and instructions printed on the rear panel of the power supply and reproduced here.
The power supply provided with the GS3000 is the RPS11 which is a linear supply and produces
the DC voltages required by the console. Always use the correct power supply and cable with the
console. The use of alternative supplies is not recommended and may cause damage. Check that
the correct mains lead with moulded plug has been supplied with your power supply. Ensure that
the IEC mains plug is pressed fully into the rear panel socket before switching on.
The extension of the DC power cable is not recommended and may result in the malfunction of the
mixing console.
It is standard practice to turn connected power amplifiers down or off before switching the console
on or off.
Before switching on your console, check that the mains voltage on
the power supply unit is set to the correct mains voltage for your
area, and that the fuse is of the correct rating and type. This is
clearly marked on the rear panel of the power supply. Do not
replace the fuse with any other type, as this could become a safety
hazard and will void the warranty.
Always switch the power supply off before connecting or
disconnecting the mixer DC power cable, removing or installing
modules and servicing.
In the event of an electrical storm, or large mains voltage
fluctuations, immediately switch off the Power Supply Unit and
disconnect the mains plug from the wall socket.