AirLive WT-2000ARM - Manual (Page 60)

AirLive WT-2000ARM User’s Manual
55
Make sure you store the username and password in a save place.
5. I cannot access the Web Management of the router after activating the ACL function.
STEPS CORRECTIVE ACTION
1 When ACL is activated, you have to set the ACL rule for allowing some users
to use some services. Check if you have set the rules. If not, all the users are
forbidden using any of service from LAN or WAN.
2 If you cannot access the Web Management of the router, please press the
Reset button over 5 seconds to restore to defaults.
3 After the router is restarting, log in the router with the default IP Address
192.168.2.1.
6. Initialization of the ADSL connection failed.
STEPS CORRECTIVE ACTION
1 Check the cable connections between the ADSL port and the wall jack. The
ADSL LED on the rear panel of the router should be on.
2 Check VPI, VCI, type of encapsulation and type of multiplexing settings are
the same as what you collected from your ISP.
3 Restart the router. If you still have problems, you may need to verify your VPI,
VCI, type of encapsulation and type of multiplexing settings with the ISP.
7. I cannot get a WAN IP address from the ISP.
STEPS CORRECTIVE ACTION
1 The ISP provides the WAN IP address after authenticating you. Authentication
may be through the user name and password, the MAC address or the host
name.
2 The username and password apply to PPPoE and PPoA encapsulation only.
Make sure that you have entered the correct Service Type, User Name and
Password (be sure to use the correct casing).
8. Internet connection disconnects.
STEPS CORRECTIVE ACTION
1 Check the schedule rules.
2 If you use PPPoA or PPPoE encapsulation, check the idle time-out setting.
3 Contact your ISP.