AirLive WN-350R - Manual (Page 75)

2. System and Network Setup
WN-350R User’s Manual 66
Note: In this mode, if you are informed by your
wireless ISP that the wireless settings of the access
point is changed, please configure the router in this
page for match the settings.
staEnable: enable this function and the router can only
allow to be connected through wired Ethernet cable for
WAN access service.
SSID (2): This is the name of wireless network. Input the SSID
name that your wirelesses ISP provide to you.
Channel Number (3): This is the radio frequency used to transmit and receive
the wireless signal. The wireless devices in the same
network should follow the same setting. Select the
channel designated by your wireless ISP.
Site Survey (4): Click ‘Select Site Survey’ button, then a “Wireless Site
Survey Table” will pop up. It will list all available access
points nearby. Select the access point designated by
your wireless ISP in the table and the router will join
wireless network through this access point.
Security Settings (5): If the access point enables wireless security, you have to
follow the same settings in order to access the access
point. Click to set security settings for this connection
(Please go to section ‘2-7-3 Wireless Security’ for
detailed instructions).
After you finish with all settings, please click ‘Apply’ (6) button and the following
message will be displayed on your web browser: