AirLive WH-5000A - Manual (Page 36)

33 AirLive WH-5000A User’s Manual
WH-5000A Serials User Guide
` Spanning Tree Protocol (STP) 802.1d:
It should be enabled if there is any possibility that a bridging loop could occur. If you are certain that
there is no possibility that a bridging loop will occur, you can disable Spanning
Tree Protocol, because the bridge will be more efficient (faster) without it. However, if not sure,
the safest solution is to enable Spanning Tree Protocol.
` Remote AP’s MAC Address
This section list the remote bridge’s information, port number, signal strength and note. Moreover, if
you don’t want to link with some remote bridges, click the check box at the left side of port number
and confirm by clicking “Delete”.
5.3 Wireless Bridge – Radio
Click the entry on the left hand navigation panel for Wireless Bridge - Radio. This directs
you to the Wireless Access Point – Radio page.
` MAC Address:
This is the MAC Address for WLAN card and as BSSID for the bridge devices at the other end that
want to link with this unit. The Wireless Bridging uses the BSSID for purposes of
establishing contact.
` Wireless Mode:
Support 802.11 b/g Mixed, 802.11g Super, 802.11a and 802.11a turbo
` Tx Rates:
When set to AUTO, the unit attempts to select the optimal rate for the channel. If a fixed rate is used,
the unit will only transmit at that rate.
` Channel No:
The channel number is a means of an assigning frequency that device uses it to transmit/receive
data. The channel number should be same as the one using on the devices those will be bridge
together.