AirLive WH-5000A - Manual (Page 21)

18 AirLive WH-5000A User’s Manual
WH-5000A Serials User Guide
3.2 System Configuration – Operating Mode
Click the entry on the left hand navigation panel for System Configuration – Operating Mode. This directs
you to the System Configuration – Operating page.
Select the radio of Wireless Access
Point, Wireless Bridging or Wireless Client to
switch
WH-5000A to AP, Bridge or Client
mode and press Apply button.
This screen allows you to set the
operating mode to Wireless Access
Point, Wireless Bridge or Wireless
Client mode. You only need to visit this
page if you will be changing modes. Note
that if you change modes your configuration
will be lost.
3.3 System Configuration – WAN
Click the entry on the left hand navigation panel for System Configuration – WAN. This directs you to the
System Configuration – WAN page.
` Static IP
The default setting of WAN port IP is “Specify
a static IP address”. You need
input the information that the AP
requires in order to allow the WH-
5000A access to the wired LAN. This
will be the IP address, Subnet Mask,
Default Gateway, and, where needed,
DNS1 and 2. The default WAN port value is
IP Address: 192.168.254.254,
Subnet Mask: 255.255.255.0,
Default Gateway: 192.168.254.1.
Static IP
!
Note: After changing the network address you will no longer be able to access the above configuration
page with the default IP address. You will have to change the browser URL to reflect the new IP
address and log in again.