AirLive POE-FSH2422G-390 - Manual (Page 7)

1. Introduction
AirLive POE-FSH2422G-390 User’s Manual
2
1.2 Guide to the Chapters
Chapter 1
Introduction and Quick Setup guide. All the essential information including IP Address and
Password information are in the Quick Setup section.
Chapter 2
Detail installation instruction including module information and how to make Cat. 5 cable
Chapter 3
LED indicators
Chapter 4
Detail information on Web management including how to setup remote management.
1.3 Quick Setup
This section provides the essential information for experienced users to operate the switch
immediately. For detailed installation instruction, please see chapter 2 for more information.
Power-On the switch
„ The POE-FSH2422G-390 Switch has a built-in power supply to operate with 100 ~
240V AC, 50 ~ 60Hz power source.
„ The AC power cord connector is located at the rear of the unit and the On/Off switch is
next to the connector.
„ After the Switch is powered on, it will perform “self-diagnostic” test. This process takes
about 10 seconds to complete.
„ It is recommended that you install the switch with an UPS to
protect from potential power surge.
The default password is airlive
„ This switch is using 48V 802.3af PoE standard. It does not work
with passive PoE. Do not connect with passive PoE devices.
The default IP address: 192.168.2.1
The default username is admin
Important Information