AirLive POE-FSH2422G-390 - Manual (Page 13)

2. Installation of the Switch
AirLive POE-FSH2422G-390 User’s Manual
8
1000BASE-T Gigabit Ethernet Ports (Port 25~26)
The Switch four Gigabit twisted pair ports, supported auto negotiable 10/100/1000Mbps
and auto MDI/MDIX crossover detection function, this function gives true “plug and play”
capability, just need to plug-in the network cable to the hub directly and don’t care if the end
node is NIC (Network Interface Card) or switch and hub. These ports can operate in
half-duplex mode for 10/100Mbps and full- duplex mode for 10/100/1000Mbps.
Note: When the port was set to “Forced Mode”, the Auto MDI/MDIX will be disabled.
Combo mini-GBIC Ports (Port 25~26)
The Switch is equipped with two combo mini-GBIC ports, supported optional
1000BASE-SX/LX mini-GBIC module. The 1000BASE-T port 25 and 26 are the same ports
with the mini-GBIC port 25 and 26, when plug in the mini-GBIC module, the device will
activate mini-GBIC, and the RJ45 port will be disabled.
Reset
The Reset button is to reset all the setting back to the factory default.
Note: Be sure that you recorded the setting of your device, else all the setting will be
erased when pressing the “Reset” button.
The Rear Panel
The 3-pronged power plug is placed at the rear panel of the switch right side shown as
below.
2.3 Installation Site Preparation
You can mount POE-FSH2422G-390 24-Port Full Power 802.3af PoE Switch either on
desktop or on a 19-inch rack. If you plan to mount the switch on desktop, please choose a
steady, level surface in a well-ventilated area that is free from excessive dust. In any case,
the installation site chosen for your switch has to comply with the following requirements: