AirLive POE-FSH2422G-390 - Manual (Page 37)

4. Web Management
AirLive POE-FSH2422G-390 User’s Manual
32
In Port Based Mode you see a matrix of your 8 Ports. Simply select the port on top screen
you want to configure, click on Read, and then select or deselect the ports that are on the
same VLAN group. In this configuration mode you do not need to worry about defining
VLAN groups and VLAN IDs.
VLAN Member in Tag Based Mode
In Tag Based Mode you need to define and configure your VLAN groups. Since you want
the handover to other switches take place smoothly, the VLAN IDs (Numbers) need to be
like on the rest of your network. On other switches you may have the chance to configure
names. These are just for your reference. Only the numbers are important!
There firstly add your VLAN Groups (identified throughout your network by unique and
constant numbers). Start with IDs from 100 and up. Keep in mind that some switches use
“1” as the default, while others use “4095” or “4096” as default. Starting with 100 gives you
enough free room and less compatibility issues.
So enter “100” in the field right of VID Setting, then select or deselect which ports are
member of that group. Your up- and downlink ports need to member of every existing group!
Then click on add. The new group with its setting will be displayed at the bottom of the
screen.
With the PVID Setting you define to which VLAN group incoming traffic belongs. Consider
the example that Port 1 is member of group 100 and 101. A simple PC is connected to Port
1. If that PC is now sending out data, with PVID you define if that data is for group 100 or
101.