AirLive G.DUO - Manual (Page 119)

12. Frequent Asked Questions
AirLive G.DUO User’s Manual 112
Question : Why can’t I get SNMP access?
Answer: The SNMP management interface is turned off by default. Please go to
“System Configuration-> SNMP Management” menu to enable it.
====================================================================
Question : Where is the POE port for G.DUO?
Answer: The PoE system used for G.DUO is 12V Passive PoE. LAN1 is also used as
the passive PoE port.
====================================================================
Question : Where is the signal survey function that displays the signal strength
continuously for antenna alignment?
Answer: The “Signal Survey” function is inside the Site Survey function. After the site
survey, please select a SSID and press the “Signal Survey” button. The
signal strength is indicated by percentage, not by SIGNAL STRENGTH
.
The higher the number, the stronger the signal.
====================================================================
Question : Why can’t I perform emergency upgrade correctly?
Answer: 1. Please make sure you are connecting your PC to LAN2, LAN3, or LAN4.
Do not connect to LAN 1.
2. You need special firmware for emergency upgrade. Please visit
www.airlive.com to download the file.