Gsm incoming groups – 2N VoiceBlue Next v3.5 User Manual
Page 54
54
GSM incoming groups
2N VoiceBlue Next
®
allows you to work with two groups of incoming calls for each of
which you can set variable connection set-up modes.
General settings
Mode – set how the gateway should process incoming GSM calls:
Reject incoming calls – all incoming GSM calls are automatically rejected.
Ignore incoming calls – all incoming GSM calls are ignored. The calling
subscriber gets the check ringing tone.
Accept incoming calls + voice message – incoming GSM calls are received
and, if preset so, the DTMF dial-in with a voice welcome note is activated.
Accept incoming calls + dialtone – incoming GSM calls are received and, if
preset so, the DTMF dial-in function with a simulated secondary dialtone is
activated.
CallBack after ring / Reject – in case the CallBack table includes the CLIP, a
CallBack is made. CLIP-less incoming calls are rejected.
CallBack after ring / Ignore – in case the CallBack table includes the CLIP, a
CallBack is made. CLIP-less incoming calls are ignored.
Report to PC + voice message – the GSM gateway sends information on
incoming calls to a PC equipped with the call routing software. The DTMF
dial-in with a voice welcome note can be activated for incoming calls.
Report to PC + dialtone – the GSM gateway sends information on incoming
calls to a PC equipped with the call routing software. The DTMF dial-in with
a simulated secondary dialtone can be activated for incoming calls.
Minimum digits in DTMF – set the minimum count of digits to be required by the
gateway for DTMF dial-in.
Maximum digits in DTMF – set the minimum count of digits to be accepted by the
gateway for DTMF dial-in.
DTMF dialling timeout [s] – set the time for the GSM gateway to wait for the first
/ next DTMF digits. If you set this parameter to 0, the incoming call is
automatically connected to the numbers included in the
.
List of called numbers
Day of deleting GSM incl. group statistics – define a day in a month on which the
statistics on incoming calls should be deleted.
Prefix before DISA dial-in – enter a numerical prefix to be automatically inserted
before the DTMF dial-in.
CLIP – use this parameter to modify the CLIP from GSM/UMTS networks. '+' is
removed automatically from international identifiers. Use '–' to remove a digit.
Examples (GSM CLIP +420600123456):
Caution
We recommend you to set the free minute counter value to X–5, where X
is the count of free minutes obtained from the GSM/UMTS provider to
avoid limit excesses.
The manufacturer is not liable for any additional call costs in case the
GSM/UMTS provider's free minute/SMS limits are exceeded.