2N VoiceBlue Next v3.5 - Manual (Page 51)

51
2N TELEKOMUNIKACE a.s., www.2n.cz
®
GSM group assignment
You can assign the GSM/UMTS modules to groups separately for incoming and outgoing
calls. See the two items below for outgoing and incoming group settings.
GSM outgoing groups
2N VoiceBlue Next
®
allows you to work with two groups of outgoing calls for each of
which you can set variable connection set-up modes and count of used minutes and
sent SMS messages for a selected period.
General settings
Delay for CONNECT [s] – define a delay before sending information on the
connected call after receipt from GSM.
Minimum ring duration to send SMS at no answer [s] – set the minimum ringing
time for an outgoing call to GSM/UMTS before the SMS at no answer is sent.
Delay for ALERTING [a] – define a delay before sending information on ringing
start.
Minute parameter – select whether or not the GSM gateway should record the
call length or count for outgoing call restriction.
Day of deleting statistics in group (every month) – define a day on which
statistics on disconnected calls should be deleted.
Generate virtual ring tone – enable/disable generation of the virtual ringing tone
to the VoIP interface.
Call length counting: select whether the call should be counted in seconds or
minutes.
BTS lock – identify the BTS to which the GSM modules should be logged fixedly.
Restart the selected GSM modules to execute the changes.
After call relax delay – interval between the current call termination and next call
setup via the same GSM/UMTS module. 2 seconds is recommended for
high-traffic installations.
Disconnect call
Specify the reasons for an immediate disconnection of an outgoing GSM/UMTS call.
Note
The function works properly only if the INVITE SMS at no answer
message contains the called and caller numbers.
Caution
The BTS lock service works with specific GSM modules only (Q55)!
An error in BTS identification results in a GSM module login failure.