2N Helios IP Automation Manual v2.7 - Manual (Page 19)

19
2N TELEKOMUNIKACE a.s., www.2n.cz
®
4. Actions
2N Helios IP Automation
®
– defines the following types of actions:
ActivateSwitch – switch activation
SetOutput – digital output state setting
BeginCall – outgoing call setup
AnswerCall – incoming call answer
EndCall – call termination
SendHttpRequest – HTTP command sending
SendMulticastRequest – command sending to multiple devices
PlayUserSound – user sound playing
StartMulticastSend – audio stream sending start
StopMulticastSend – audio stream sending stop
StartMulticastRecv – audio stream receiving start
StopMulticastRecv – audio stream receiving stop
SetCameraInput – camera input selection
ControlRtpStream – call RTP stream control
LogEvent – event logging to the syslog server
SendEmail – email sending
Action.ActivateSwitch
The block defines the action necessary for activation of the intercom ActivateSwitch
switch as configured in the Switch 1–4 tags. The activity to be performed depends fully
on the particular switch settings (digital output activation, HTTP command sending,
etc.). Switch deactivation is controlled by the switch settings too.
Parameters
Event – define the event to launch the action.
Condition – define the condition to be met to execute the action. This parameter
is optional.
Switch – define the switch to be activated (1 to 4).